Maintenance and maintenance of button bits rock drilling

The button bits rock drilling completes the drilling task with the cooperation of the drilling rig and other supporting drilling equipment. As a rock cutting drilling component, it has a certain service life.

The button bits rock drilling completes the drilling task with the cooperation of the drilling rig and other supporting drilling equipment. As a rock cutting drilling component, it has a certain service life. Therefore, maintenance must be carried out in time after each drilling, which is also related to the service life of the drill bit.

Electroplating maintenance and maintenance:
The manufacturer of button bits rock drilling tells you that proper and timely maintenance can also prolong the life of electroplated drill bits and reduce drilling costs to a large extent. Clean the head carcass of the electroplating drill bit in time, observe whether there is tire loss and rigid body cracking, and the wear degree of the diamond section. When the drill bit cannot complete the drilling and core work, it is the drill bit that needs to be replaced.
If the drill rigid body and matrix of the electroplated drill bit are intact, but the drilling efficiency is low or slipping occurs, then it is necessary to replace the 6-8 degree diamond drill bit of the gold drill, or manually lift the matrix of the drill bit out of the way Enhance footage efficiency. The manufacturer of button bits rock drilling tells you that in order to ensure that the electroplated drill bit maintains better footage efficiency every time it is used, it should be cleaned and checked after each use.
button bits rock drilling is also a kind of geological diamond drill bit, it has two types of coring and non-coring, but any one needs regular care and maintenance, after each drilling is completed, check the wear of the alloy, when the outer diameter bar wears more than 2/3, if you continue to use, you should replace the drill bit or re-weld alloy. Check the cutting compound on the drill for severe wear. If the number of remaining pieces is less than 1/5, it can no longer be used and needs to be replaced or re-cut in time.